What is the process of basin faucet installation?

In the bathroom, the faucet occupied the most important position. There was no faucet and the bathroom was in a paralyzed state. The installation of the faucet was very simple. Instead of looking for a repair company every time to help, Xiaobian gave everyone the popularity of a Basin Faucet installation process.

The specific process of basin faucet installation is divided into the following steps:

The first step: Take out the faucet and check whether all accessories are complete. Before installation, be sure to remove the dirt around the installation hole and the water supply pipe to ensure that there is no impurity in the inlet pipe. To protect the surface of the faucet from being scratched, it is advisable to wear gloves for installation.

Step 2: Remove the rubber gasket, which is used to relieve the pressure on the metal surface of the faucet in contact with the ceramic basin, protect the ceramic basin, insert a water inlet pipe, and tighten.

The third step: thread the threaded joint into the first water inlet hose, and then insert the second water inlet hose into the water end through the threaded joint.

Step 4: Screw the second water inlet hose into the inlet port. Pay attention to the correct direction and use force to equalize. Then tighten the threaded joint.

Step 5: Put the two water inlet hoses into the white rubber pad.

Step 6: Put on the locking nut to fix the tap.

Step 7: Then tighten the sleeve.

Step 8: Lock the two water inlet pipes and the angle valve respectively and do not twist the pipe wrench to prevent deformation or even twisting. Pay attention to the connection of hot and cold water. Connect the water outlet angle valve with the other end of the inlet pipe.