How to fix the faucet leak How to prevent faucet leaking

When using a faucet, I believe that many of my friends often encounter water leakage after the faucet is tightened. Some people who encounter this situation will directly replace the faucet. In fact, there are many reasons for the leakage of the faucet. It can be handled according to its situation. So how can you fix a faucet leak ?

1, how to repair leaking faucet - after the valve is closed, the faucet is still out of water

In this case, the pressure cap may loosen or the deformation of the apron at the bottom of the valve plug may be caused. For the former, it is recommended that the handle and the decorative cover can be removed and the pressure cap can be tightened again. If the latter is the case, it is recommended to remove the valve core. Check the rubber ring and reinstall it.

2, how to repair the tap leaking - water seepage from around the valve core

If you encounter this phenomenon may be the valve core loose or offset, it is recommended to remove the valve core to re-install once.

3, how to repair tap water leakage - water seepage from the middle of the valve core

If the above phenomenon is encountered, it indicates that the spool is damaged. At this time, it is recommended to replace the spool only.

4, how to repair leaking faucet - leading bottom leakage

Encounter this phenomenon may be caused by the inlet pipe O-ring is not installed or deformed, it is recommended to unscrew the hose to see if the O-ring is loose, if you loosen and reinstall it. If it is found that the O-ring has been deformed, it is recommended to replace the O-ring.

How to prevent faucet leaking :

1, choose ceramic and copper body spool

When buying a faucet, it is necessary to look at the material of the faucet. The valve core of the high-grade faucet is made of hard ceramic and copper. The feel is comfortable, smooth, and the number of opening and closing can be several times. The low-grade faucet built-in valve core uses a steel ball valve. The rubber ring in the steel ball valve core is easy to wear out and deteriorate, and the water leakage phenomenon easily occurs over time.

2, control the intensity of the switch tap

When using the faucet, it is necessary to control the strength of the switch faucet, because the valve plug has been adjusted to open and close the angle. Excessive effort is often used to open the tap valve core, which will cause damage to the spool and lead to dripping or water leakage. In addition, as far as possible, the sand in the inlet pipe should be drained before installing and installing the faucet, and then the inlet pipe of the faucet should be connected to prevent the leakage of sand and other foreign matter from flowing into the faucet spool.