How to do faucet installation tips for kitchen faucet dripping

The faucet is always inseparable from our life. When we choose the faucet, everyone thinks about its quality. When we use it, everyone will consider how the faucet drip? We don`t know how to do it. It is. Today, Xiaobian will take a look at how to do the kitchen faucet dripping and what are the faucet installation skills!

How to do the Kitchen Faucet dripping?

1. After the valve core is closed, the faucet still effluent. In this case, the pressure cap may be loose or the rubber ring at the bottom of the valve core may be deformed. For the former, it is recommended to remove the handle and the decorative cover, and then retighten the pressure cap. In the latter case, it is recommended to take out the valve plug, check the condition of the rubber ring, and then reinstall it.

2. The water seeps out from around the valve core. If this phenomenon is encountered, the valve core may be loose or offset. It is recommended to take out the valve core and reinstall it once.

3. The water seeps out from the middle part of the valve core. If the above phenomenon is encountered, it means that the valve core is damaged. At this time, it is recommended to replace the valve core.

4. Leakage at the bottom of the faucet. This phenomenon may be caused by the O-ring of the inlet pipe not being installed or deformed. It is recommended to unscrew the hose to see if the O-ring is loose. If it is loose, reinstall it. If the O-ring has been changed

Shape, it is recommended to replace the O-ring.

Faucet installation tips

1. Before installing the thermostatic faucet, be sure to check in advance whether the water pipe is installed to the left and the right is cold. When connecting, the hot and cold water pipes must not be connected incorrectly, and it will not affect the normal use. If you are using gas or solar water heaters, you can't use the thermostat. Because the water pressure is too low, you can't get the desired effect.

2. When installing the wall faucet, it is reminded that the water pipe must be washed first, so that it will not cause damage to the faucet. In addition, the spacing of the hot and cold water pipes is also controlled during installation, and its distance is generally controlled. At 15 cm, if it is lower than this distance, it will affect the use.

3, single hole faucet should also pay attention to the installation, this faucet is installed in the kitchen more, but also the use frequency is higher, the time is prone to looseness, so the lock nut must be tightened.

4. When installing the single-hole basin water dragon, you should pay attention to some details. You can't forget to wash the water pipe buried in the wall before installation. If you find that the water inlet pipe is too long, you can intercept it according to your own needs. But here you should remind you not to bend to 90 degrees or more than 90 degrees.